Why connected?

Interlinked alarms give you the best chance of escape as all alarms sound when there is an activation. 

The FireAngel Connect range delivers the ultimate level of protection for every home. Create a network between your Smart RF Smoke, Heat and Carbon Monoxide alarms by wirelessly interconnecting. 

The FireAngel specification range comes with a 5-year warranty. 

Our Connected Home Fire Safety Pack offers longterm value and convenience with 10 year sealed lithium batterys and no costly installation charges compared with mains wired alarms. 

The most cost effective way of giving maximum protection when replacing your smoke, heat and CO alarms for non new dwellings that already have hardwired interconnected alarms. Future proof your home against any new fire safety legislation or home insurance requirements.

 Key Features 

  • Easy to install 
  • Connects Wirelessly with Smart RF Technology
  • Multiple network options
  • Sleek Design
  • 5 Year Warranty
  • 10 Year Sealed Battery

Creating an interlinked network with wireless communication.

Follow below instructions 

  1. Install Alarm 1 as described in the manual (battery powered install here or mains powered install here).
  2. Then install the base plate for Alarm 2 in one of the recommended locations.
  3. Using a ballpoint pen briefly push and release the ‘learn button’ on the back of Alarm 2. The red LED next to the learn button will flash briefly then light up for approximately five seconds.
  4. During these five seconds you need to briefly press the test button on Alarm 1 to wirelessly interlink the two alarms. Alarm 1 will give an audible sound consisting of two cycles of three loud beeps.
  5. The red LED on the wireless module of Alarm 2 will flash to indicate that it has been ‘learned-in’ successfully. If the test button is not pressed quickly enough, the ‘learn-in’ process will fail. If this happens, repeat the process.
  6. To complete the installation, fit Alarm 2 onto it’s base plate.

Or watch below video